Tucson FWD V6-2.7L (2009)
Tire Pressure Sensor: Procedures
Sensor Initiating Procedure
NOTE:
The sensor's default state will be Storage Auto (High Line).
1. Change the newly installed sensor mode to Normal Fixed Base(Low Line) with the 'TPMS exciter'.
NOTE:
Mode(Status/option) of the sensor installed to the vehicle should be Normal Fixed Base (Low)
2. Read the four sensor's ids starting with sensor 1 (1 normally front left, 2 front right, 3 rear left, 4 rear right).
NOTE:
Note that sensors which were already configured as Base (Low Line) will take longer to read.
3. Connect 'TPMS exciter' to the diagnostic connector.