Tucson FWD V6-2.7L (2009)
13. Using a plier or flat-tipped (-) screwdriver, remove the clamp on the side of the wheel.
14. Pull out the joint(BJ) on the side of wheel in the transaxle direction.
Be careful not to damage the boot.
Reassembly
Reassembly (DOJ-BJ)
1. Wrap tape around the driveshaft splines (DOJ. side ) to prevent damage to the boots.
2. Apply grease to the driveshaft and install the boots.
3. To install the dynamic damper, keep the BJ. and driveshaft in a straight line and secure the dynamic damper with the dynamic damper band.
Standard value mm(in.): 515(+2, 0), 20.3(+0.079,-0)
4. Apply the specified grease to the inner race(A) and cage(B). Install the cage(B) so that it is offset on the race as shown.
CAUTION:
Use the grease included in the repair kit.