Veracruz AWD V6-3.8L (2007)
Canister Purge Solenoid: Testing and Inspection
Emission Control System
PURGE CONTROL SOLENOID VALVE (PCSV)
INSPECTION
NOTE: When disconnecting the vacuum hose, make an identification mark on it so that it can be reconnected to its original position.
1. Disconnect the vacuum hose from the solenoid valve.
2. Detach the harness connector.
3. Connect a vacuum pump to the nipple which is connected to intake manifold.
4. Apply vacuum and check when voltage is applied to, the PCSV and when the voltage is discontinued.
Battery voltage
Normal condition
When applied
Vacuum is released
When discontinued
Vacuum is maintained
5. Measure the resistance between the terminals of the solenoid valve.
PCSV coil resistance(ohm) : 19.0 - 22.0 ohms at 20 °C (68 °F)
