Veracruz FWD V6-3.8L (2009)
22. Remove the drive belt auto tensioner (A).
23. Remove the water pump pulley (A).
24. Remove the timing chain cover (A). If necessary remove the water pump (B) first.
NOTE:
Be careful not to damage the contact surfaces of cylinder block, cylinder head and timing chain cover.
Before removing the timing chain, mark the RH/LH timing chain with an identification based on the location of the sprocket because the
identification mark on the chain for TDC (Top Dead Center) can be erased.
25. Install a set pin after compressing the timing chain tensioner.
