Veracruz FWD V6-3.8L (2009)
Tightening torque
: 1.2 - 1.3 kgf.m (11.8 - 12.7 N.m, 8.7 - 9.4 lb.ft)
7. Connect the Passenger Airbag (PAB) harness connector to the SRS main harness connector.
8. Reinstall the glove box.
9. Reconnect the battery negative cable.
10. After installing the Passenger Airbag (PAB), confirm proper system operation:
A. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Components and Components Location
Components
Repair Procedures
Removal
1. Disconnect the battery negative cable and wait for at least 3 minutes before beginning work.
2. Remove the front seat assembly.
3. Remove the seatback cover.
NOTE:
When the side airbag deployed after a collision, replace the seatback as an assembly.
4. Loosen the SAB mounting nuts and remove the SAB module.
Installation
