Veracruz FWD V6-3.8L (2009)
In order to prevent overlapping of rushing current when the motor starts up, motor start-up is delayed for 100 ± 10 ms respectively and its
operational priority is as follows.
Slide>Reclining>Front height>Rear height
9. Sequential timer settings for motor start-up.
Slide : 20 ± 2 seconds (in memory replay)
Reclining : 35 ± 3 seconds (in memory replay)
Front height : 7 ± 1 seconds
Rear height : 15 ± 1 seconds
** Slide, Reclining: It operates depending on the switch input time in manual switch input (direct drive type)
Registration And Replay By The Keyless
1. Keyless registration operation
(1) Ignition ON and OFF positions are registered corresponding to the keyless codes.
(2) Keyless codes are determined by the keyless door lock operation.
2. Keyless replay operation
(1) Upon door unlock operation when the ignition is OFF, it automatically set the registered positions corresponding to the keyless code.
However, seat slide is automatically set to the following positions.
(2) If any of the following conditions is met, keyless replay operation is prohibited and operation stops if it is in operation.
A. When the P position switch is OFF.
B. When the switch is in manual operation.
C. When the stop switch is ON.
Buzzer Output
1. In case of memory permit status (memory switch is ON) : once
2. When memory registration is complete (position switch is ON) : twice
3. When the memory replay is in operation (position switch is ON) : once
4. When error is detected due to the sensor failure : 10 times
Error Detection
1. If the sensor fluctuations of slide and front/rear height for one second after motor start-up are less than 6 pulses and 4 pulses respectively, and if
the sensor fluctuation of reclining for 3.5 seconds is less than 50mV, it is determined that the harness is short or sensor is fail.
2. Countermeasure when error is detected.
Stop the operation if it is in auto replay. Though, it should be operable manually. When the failure is completely repaired, it can be automatically
adjusted from the stop of auto replay. If the position sensor senses the pulse from the position sensor by the manual operation, we judge it is
complete. This is called stop release of automatic operation.
