Veracruz FWD V6-3.8L (2009)
11. Cut and remove the tilt motor connector harness wire tie.
NOTE:
The location of the wire tie and the adjacent harness to which it is attached. The new limit switch will be re-attached to the same harness.
12. Remove the telescope limit switch (O) and tilt limit switch (N) by removing the 4 screws as shown. Note the position of the steel bracket held in
place by the tilt switch lower mounting screw. This bracket provides a track for the telescope switch and must be re-installed with the new switches in the
same position.
13. Using the appropriate tool, lift up the tilt motor connector's pin lock as shown and set it aside.
14. Locate the tilt limit switch's wires (P, Q, R) on the back of the tilt motor connector as shown.
P - Red with white stripe
Q - Black with white stripe
R - Brown with white stripe
