Veracruz FWD V6-3.8L (2009)
CAUTION:
Do not hit too strongly with hammer.
3. Disassemble snap ring(A) on the yoke.
4. Disassemble the case(A) by using hammer as shown in the illustration.
CAUTION:
-
Do not hit too strongly with hammer.
5. Installation is the reverse order of removal.
Inspection
Inspection
CV Joint And Boots
1. Shift the transaxle to Neutral.
2. Raise the vehicle off the ground, and support it with safety stands in the proper locations.
3. Check the center bearing (A) for excessives play or rattle and rubber for rent. If the center bearing (A) has excessive play or rattle and rubber has
rent, replace the propeller shaft assembly.
