Veracruz FWD V6-3.8L (2009)
Transmission Temperature Sensor/Switch: Service and Repair
Removal
1. Remove the TCU. (refer to TCM's Removal)
CAUTION:
Do not touch the terminals.
2. Drain the oil by removing the overflow plug and the O-ring using a torx wrench (T40), and the drain plug (A) and the gasket by using a hexagon
wrench (17mm).
3. Disconnect the oil cooler hoses from the tubes.
4. Remove the 2 bolts to remove the oil cooler tubes (A) and the O-rings.
5. Remove the transaxle side cover and the valve body assembly. (refer to Solenoid valve's Removal))
CAUTION:
Be careful not to drop the valve body assembly.
6. After removing the wire lock plate (A), remove the wire (B) from the transaxle case.
CAUTION:
-
Be careful not to damage the harness.
-
Be careful not to pull the harness forcibly.
7. Remove the O-ring (B) and the gasket (C) from the wire (A).