Veracruz FWD V6-3.8L (2009)
7. Connect the oil cooler hoses from the tubes.
8. Install the drain plug (A) and the gasket by using a hexagon wrench (17mm).
Tightening torque :
35-61 Nm (3.5-6.1kgf.m, 25.3-44.1 lb-ft)
Install the TCU. (refer to TCM's Installation)
Tightening torque :
20-30 Nm (2.0-3.0kgf.m, 14.5-21.7 lb-ft)
Bolt size (8) :M8x1.25x20mm
9. Refill the ATF. (refer to Procedure of Oil level adjusting)
10. Perform N position learning. (refer to Troubleshooting's 'How to perform N position learning')
11. Perform initial learning. (refer to Troubleshooting's 'How to perform initial learning')
