XG 350 V6-3.5L (2002)
1. Remove the lower anchor cover and loosen the anchor bolt.
Tightening torque
Lower anchor bolt: 40-55 Nm (400-550 kg.cm, 29-40 lb.ft)
2. Remove the center pillar trim and upper anchor bolt.
Tightening torque
Upper anchor bolt: 40-55 Nm (400-550 kg.cm, 29-40 lb.ft)
3. Remove the front seat belt retractor.
4. Installation is the reverse of removal.
CAUTION
1. A pretensioner functions one time only. Be sure to replace the pretensioner seat after it is deployed.
2. Do not attempt to disassemble or repair the seat belt pretension. If it malfunctions, replace it with a new pretensioner seat belt.
3. Be cautions in handling a pretensioner seat belt, and do not expose it to water or oil. If crushed, damaged, or deformed, replace it with a new
one.
4. Connect the battery only after the installation of the pretensioner seat belt has been correctly completed.
5. Removal of the pretensioner seat belt:
-
Make sure that the ignition is "Off".
-
Disconnect the negative (-) battery terminal and make sure it does not come into contact with the body.
-
Wait for about 1 minute.
-
Pull the plug from the connector at the gas generator.
-
Loosen the bolt and remove the belt from the vehicle body.