Workshop Manuals Factory service & repair Infiniti

Infiniti common faults and how to fix them

Faults that are well known on Infiniti models we hold manuals for: what the owner notices, what causes it, and the pages in our manuals that cover the repair.

G35 camshaft sensor and crank sensor recall: I35, G35, M45 and Q45 (2002–2003)

Symptoms

The engine stalls while driving or will not restart, the Service Engine Soon light comes on, and power may be reduced. Codes for the crankshaft position sensor (P0335) or camshaft position sensor (P0340) may be stored.

Cause

Infiniti campaign 03-072 covers the 2002–2003 I35, 2003 G35 saloon and coupe, 2003 M45 and 2002 Q45 with the VQ35DE V6 and VK45DE V8. Infiniti found that the engine might stop running while being driven if the crank position sensor or the cam position sensor failed, and treated it as a safety defect. The same sensors were recalled on the Nissan twins.

Fix

Check with an Infiniti dealer that the campaign has been carried out, using the vehicle's VIN; the remedy replaces the sensors free of charge. If a car that has had the campaign still shows Infiniti P0340 or P0335, check the sensor wiring and connectors before fitting another sensor. The G35 crank sensor campaign lists the VIN ranges affected for each model.

Repair instructions on this site

Sources: Infiniti campaign 03-072 (December 2003).

Infiniti P0011: variable valve timing codes and sprocket rattle (1997–2008)

Symptoms

The check engine light comes on with a valve timing code: P0011, P0014, P0021, P0024, P1110 or P1135. There may also be a rattle from the camshaft sprockets or other engine noise.

Cause

Infiniti V6 and V8 engines (VQ35, VH41, VK45 and VK56) move their camshafts with engine oil, using variable valve timing solenoid valves and sprockets. An Infiniti bulletin covering all 1997–2008 models with variable valve timing warns technicians not to replace the solenoid valves or sprockets without completing the full diagnosis, which starts with the engine oil level.

Fix

Check the oil level first and top it up, as the bulletin says, then work through the complete diagnosis in the service manual. Do not replace the Infiniti P0011 solenoid valve or the sprockets until the diagnosis points to them. Keep to the correct oil grade and change intervals, as dirty or low oil affects the valve timing. If a sprocket rattle persists once the oil is right, inspect the timing chain and sprockets.

Repair instructions on this site

Sources: Infiniti technical service bulletin, MIL on with multiple DTCs (variable valve timing).

Infiniti P0300 on the FX35: blistered ignition coils and misfires (2003–2008)

Symptoms

Misfire codes P0300 to P0306, rough running, hesitation on acceleration, and sometimes an engine that cranks but won't start. When the coils are removed, one or more has a blistered, deformed or melted outer surface.

Cause

Infiniti bulletin 11-017 covers the 2003–2008 FX35. Its repair starts with the electrical connections rather than the coils: a steering member mounting bolt on the right-hand side of the instrument panel, the engine harness grounds and the negative battery cables. So the grounding is dealt with before any coils are replaced.

Fix

Follow the Infiniti P0300 bulletin in order: replace the steering member mounting bolt on the right-hand side of the dash, clean the engine harness grounds, and replace both negative battery cables, fitting new bolts at the cable ends rather than cleaning and reusing them. Then remove and inspect all six ignition coils and replace any that are blistered. Clear the codes and road test.

Repair instructions on this site

Sources: Infiniti technical service bulletin 11-017 (March 2011).