EX35 AWD V6-3.5L (VQ35HR) (2009)
Trunk / Liftgate Weatherstrip: Service and Repair
Removal and Installation
BACK DOOR
BACK DOOR WEATHER-STRIP : Removal and Installation
REMOVAL
Pull up and remove engagement with body from weather-strip joint.
CAUTION:
Never pull strongly on weather-strip.
INSTALLATION
1. Working from the upper section, align weather-strip mark with vehicle center position mark and install weather-strip onto the vehicle.
2. For the lower section, align weather-strip seam with center of back door striker.
3. Pull weather-strip gently to ensure that there is no loose section.
NOTE:
Check that weather-strip is fit tightly at each corner and luggage rear plate.
4. Install mounting bolts of power back door drive assembly (Back door side).