EX35 RWD V6-3.5L (VQ35HR) (2008)
CAUTION:
^
Before servicing, disconnect the battery cable from negative terminal.
^
To remove brake tube, use a flare nut wrench to prevent flare nuts and brake tube from being damaged. To install, use flare nut crowfoot
and torque wrench.
^
Do not apply excessive impact to ABS actuator and electric unit (control unit), such as dropping it.
^
Do not remove and install actuator by holding harness.
^
After work is completed, bleed air from brake tube.
^
After installing harness connector in the ABS actuator and electric unit (control unit), make sure connector is securely locked.
^
When replacing ABS actuator and electric unit (control unit), make sure to adjust neutral position of steering angle sensor. Refer to
BRC-8, "ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION: Description". See: Brakes and Traction
Control/Antilock Brakes / Traction Control Systems/Steering Angle Sensor/Adjustments