EX35 RWD V6-3.5L (VQ35HR) (2008)
CAUTION:
Be sure to connect the AC Adapter. If PC battery voltage drops the process will be interrupted.
3. Connect a battery charger:
^
Set the battery charger at a low charge rate (trickle charge).
4. Turn the ignition ON with the engine OFF.
^
The engine must be OFF (not running) during the reprogramming procedure.
5. Open / start ASIST on the Toughbook(R) PC.
6. Select CONSULT Utilities, and select CONSULT-III.
7. Wait for the "Detecting VI/MI in progress" message to clear.
8. Select the detected VI from the list. (See Figure 1.)
9. Select Connect.
10. Wait for the "Checking the firmware version" message to clear.