FX35 AWD V6-3.5L (VQ35HR) (2009)
2. Remove oil filter bracket. Refer to See: Oil Filter/Service and Repair/Oil Filter Bracket/Exploded View.
3. Remove oil pan (lower). Refer to See: Oil Pan (Lower) and Oil Strainer/Removal and Installation.
4. Remove oil strainer.
5. Loosen mounting bolts in the reverse order as shown in the figure with power tool to remove.
-
Insert the seal cutter [SST: KV10111100 (J-37228)] between oil pan (upper) and lower cylinder block. Slide seal cutter by tapping on the side of
tool with a hammer. Remove oil pan
(upper).
CAUTION:
-
Be careful not to damage the mating surfaces.
-
Never insert a screwdriver, this will damage the mating surfaces.
6. Remove O-rings (2) from bottom of lower cylinder block (1) and oil pump (3).
7. Remove axle pipe, if necessary.
-
Remove axle pipe from oil pan (upper) using a suitable drift (A)
[outer diameter: 37 mm (1.46 in)].
INSTALLATION
1. Install axle pipe (3) to oil pan (upper), if removed.