FX35 RWD V6-3.5L (VQ35DE) (2003)
Impact Sensor: Service and Repair
Side Air Bag (Satellite) Sensor
Removal and Installation
REMOVAL
CAUTION: Before servicing SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes.
1. Remove seat belt pre-tensioner.
2. Remove side air bag (satellite) sensor fixing nuts.
3. Remove the side air bag (satellite) sensor connector.
CAUTION:
-
Do not use old nuts; replace with new ones.
-
Check side air bag (satellite) sensor to ensure it is free of deformities, dents, cracks or rust. If it shows any visible signs of damage, replace it
with new one.
-
Do not disassemble side air bag (satellite) sensor.
-
Replace side air bag (satellite) sensor if it has been dropped or sustained an impact.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
-
Check side air bag (satellite) sensor for proper installation.
-
After replacement of side air bag (satellite) sensor, perform self-diagnosis to make sure that no malfunction is detected. Refer to "SRS Operation
Check". See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated
Procedures/Manufacturer Code Charts/Air Bag System/Diagnostic Procedures/Trouble Diagnosis with CONSULT-II/Diagnostic Procedure 1 -
SRS Operation Check