FX35 RWD V6-3.5L (VQ35HR) (2010)
Body Control Module: Testing and Inspection
Additional Service When Replacing Control Unit (BCM)
Description
INSPECTION AND ADJUSTMENT
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM) ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT
(BCM) : Description
BEFORE REPLACEMENT
When replacing BCM, save or print current vehicle specification with CONSULT-III configuration before replacement.
NOTE:
If "READ CONFIGURATION" can not be used, use the "WRITE CONFIGURATION - Manual selection" after replacing BCM.
AFTER REPLACEMENT
CAUTION:
-
When replacing BCM, you must perform "WRITE CONFIGURATION" with CONSULT-III.
- Complete the procedure of "WRITE CONFIGURATION" in order.
- If you set incorrect "WRITE CONFIGURATION", incidents might occur.
- Configuration is different for each vehicle model. Confirm configuration of each vehicle model.
-
When replacing BCM, perform the system initialization (NATS).
Work Procedure
INSPECTION AND ADJUSTMENT
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM) : Work Procedure
1.SAVING VEHICLE SPECIFICATION
CONSULT-III Configuration
Perform "READ CONFIGURATION" to save or print current vehicle specification. .
NOTE:
If "READ CONFIGURATION" can not be used, use the "WRITE CONFIGURATION - Manual selection" after replacing BCM.
- GO TO 2.
2.REPLACE BCM
Replace BCM. See: Service and Repair/Exploded View.
- GO TO 3.
3.WRITING VEHICLE SPECIFICATION
CONSULT-III Configuration
Perform "WRITE CONFIGURATION - Config file" or "WRITE CONFIGURATION - Manual selection" to write vehicle specification. See: Testing
and Inspection/Programming and Relearning/Configuration (BCM)/Work Procedure.
- GO TO 4.
4.INITIALIZE BCM (NATS)
Perform BCM initialization. (NATS)
- WORK END