FX35 RWD V6-3.5L (VQ35HR) (2010)
Crankshaft Main Bearing Seal: Service and Repair
OIL SEAL
REAR OIL SEAL : Removal and Installation
REMOVAL
1. Remove transmission assembly. (2WD models) or See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Service and
Repair/Removal and Replacement/7AT RE7R01A/Transmission Assembly/Exploded View (AWD models).
2. Remove drive plate. See: Cylinder Block Assembly/Service and Repair/Exploded View.
3. Remove rear oil seal with a suitable tool.
CAUTION:
Be careful not to damage crankshaft and cylinder block.
INSTALLATION
1. Install rear oil seal.
-
Install rear oil seal so that each seal lip is oriented as shown in the figure.
A : Oil seal lip
B : Dust seal lip
White arrow : Engine inside
Black arrow : Engine outside
-
Press in rear oil seal (1) to the position as shown in the figure.
B : Cylinder block rear end face
a : 0 - 0.5 mm (0 - 0.020 in)