FX35 RWD V6-3.5L (VQ35HR) (2010)
- Harness connectors M6 and E106
2. Check the continuity between the CAN gateway harness connector and the harness connector.
Is the inspection result normal?
YES - GO TO 3.
NO - Repair the main line between the CAN gateway and the harness connector M6.
3.CHECK HARNESS CONTINUITY (OPEN CIRCUIT)
1. Disconnect the connector of ABS actuator and electric unit (control unit).
2. Check the continuity between the harness connector and the ABS actuator and electric unit (control unit) harness connector.
Is the inspection result normal?
YES (Present error)-Check CAN system type decision again.
YES (Past error)-Error was detected in the main line between the CAN gateway and the ABS actuator and electric unit (control unit).
NO - Repair the main line between the harness connector E106 and the ABS actuator and electric unit
(control unit).
System Diagram
MALFUNCTION AREA CHART
System Diagram