FX35 RWD V6-3.5L (VQ35HR) (2010)
![background image](/infiniti/fx35_rwd/v6-3.5l_(vq35hr)/Page-716078.png)
UNIT : Diagnosis Procedure".
Is the inspection result normal?
YES (Present error)-Replace the lane camera unit. See: Accessories and Optional Equipment/Collision Avoidance and Parking Assist
Systems/Service and Repair/Exploded View.
YES (Past error)-Error was detected in the lane camera unit branch line.
NO - Repair the power supply and the ground circuit.
Power Supply and Ground Circuit
POWER SUPPLY AND GROUND CIRCUIT
Diagnosis Procedure
1.CHECK FUSE
Check that the following fuse are not blown.
Is the fuse fusing?
YES - Replace the blown fuse after repairing the affected circuit if a fuse is blown.
NO - GO TO 2.
2.CHECK POWER SUPPLY CIRCUIT
Check voltage between CAN gateway harness connector and ground.
Is the measurement value normal?
YES - GO TO 3.
NO - Repair harness or connector.
3.CHECK GROUND CIRCUIT
Check continuity between CAN gateway harness connector and ground.
Does continuity exist?
YES - INSPECTION END
NO - Repair harness or connector.
CAN
TPMS BRANCH LINE CIRCUIT
Diagnosis Procedure
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.