FX35 RWD V6-3.5L (VQ35HR) (2010)
Body Control Module: Testing and Inspection
Configuration (BCM)
Description
INSPECTION AND ADJUSTMENT
CONFIGURATION (BCM) CONFIGURATION (BCM) : Description
Vehicle specification needs to be written with CONSULT-III because it is not written after replacing BCM.
Configuration has three functions as follows.
CAUTION:
-
When replacing BCM, you must perform "WRITE CONFIGURATION" with CONSULT-III.
-
Complete the procedure of "WRITE CONFIGURATION" in order.
-
If you set incorrect "WRITE CONFIGURATION", incidents might occur.
-
Configuration is different for each vehicle model. Confirm configuration of each vehicle model.
-
Never perform "WRITE CONFIGURATION" except for new BCM.
Work Procedure
INSPECTION AND ADJUSTMENT
CONFIGURATION (BCM) : Work Procedure
1.WRITING MODE SELECTION
CONSULT-III Configuration
Select "CONFIGURATION" of BCM.
When writing saved data-GO TO 2.
When writing manually-GO TO 3.
2.PERFORM "WRITE CONFIGURATION - CONFIG FILE"
CONSULT-III Configuration
Perform "WRITE CONFIGURATION - Config file".
- WORK END
3.PERFORM "WRITE CONFIGURATION - MANUAL SELECTION"
CONSULT-III Configuration
1. Select "WRITE CONFIGURATION - Manual selection".
2. Identify the correct model and configuration list. See: Body and Frame/Body Control Systems/Testing and Inspection/Programming and
Relearning/Configuration (BCM)/Configuration List.
3. Confirm and/or change setting value for each item.
CAUTION:
Thoroughly read and understand the vehicle specification. Incorrect settings may result in abnormal control of ECU.
4. Select "SETTING".
CAUTION:
Make sure to select "SETTING" even if the indicated configuration of brand new BCM is same as the desirable configuration. If not,
configuration which is set automatically by selecting vehicle model can not be memorized.
5. When "COMMAND FINISHED", select "END".