FX35 RWD V6-3.5L (VQ35HR) (2010)
Side Air Bag: Service and Repair
Removal and Installation
SIDE CURTAIN AIR BAG MODULE
Removal and Installation
WARNING:
-
Before servicing, turn ignition switch OFF, disconnect battery negative terminal and wait 3 minutes or more.
-
Never use the air tools or the electric tools for servicing.
REMOVAL
1. Remove the headlining. See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and Installation.
2. Remove the side curtain air bag module harness connector.
CAUTION:
-
For installing/removing the side curtain air bag module harness connector, insert thin screwdriver wrapped in tape into notch, lift lock
and remove connector.
-
Install the connector with lock raised, and push lock into the connector.
-
After installing the connector, check that the lock is pushed securely into it.
3. Remove the fixing bolts, and then remove the side curtain air bag module.
CAUTION:
-
Never impact the side curtain air bag module.
-
Replace the side curtain air bag module if it has been dropped or sustained an impact.
· Never insert any foreign objects (screwdriver, etc.) into side curtain air bag module.
· Never disassemble the side curtain air bag module.
Never expose the side curtain air bag module to temperatures exceeding 90°C (194°F).
·
· Never allow oil, grease, detergent, or water to come in contact with the side curtain air bag module.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
-
Never damage the harness while installing.
-
If malfunction is detected by the air bag warning lamp, after repair or replacement of the malfunctioning parts, reset the memory using
self-diagnosis or CONSULT-III. See: Testing and Inspection/Scan Tool Testing and Procedures/Diagnosis System (Airbag),
"CONSULT-III
Function".