FX35 RWD V6-3.5L (VQ35HR) (2010)
4. Check continuity between automatic drive positioner control unit harness connector and ground.
Is the inspection result normal?
YES - Replace automatic drive positioner control unit. See: Accessories and Optional Equipment/Memory Positioning Systems/Memory Positioning
Module/Service and Repair/Removal and Replacement.
NO - Repair or replace harness.
3.CHECK TILT SWITCH
See: Accessories and Optional Equipment/Memory Positioning Systems/Testing and Inspection/Component Tests and General Diagnostics/Tilt
Switch/Component Inspection.
Is the inspection result normal?
YES - GO TO 4.
NO - Replace tilt & telescopic switch. See: Power Adjustable Steering Column Switch/Service and Repair/Removal and Installation.
4.CHECK INTERMITTENT INCIDENT
See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Intermittent Incident.
- INSPECTION END
Component Inspection
TILT SWITCH
Component Inspection
1.CHECK TILT SWITCH
1. Turn ignition switch OFF.
2. Disconnect tilt & telescopic switch connector.
3. Check continuity between tilt & telescopic switch terminals.
Is the inspection result normal?
YES - INSPECTION END
NO - Replace tilt & telescopic switch. See: Power Adjustable Steering Column Switch/Service and Repair/Removal and Installation.