FX35 RWD V6-3.5L (VQ35HR) (2010)
Rear Wheel Steering Actuator: Service and Repair
Rear Active Steer
Exploded View
REAR ACTIVE STEER
Exploded View
COMPONENTS
Removal and Installation
REAR ACTIVE STEER
Removal and Installation
REMOVAL
1. Remove coil spring and rear lower link. See: Suspension/Control Arm/Service and Repair/Removal and Replacement/Rear Lower Link and Coil
Spring/Exploded View.
2. Disconnect harness connector from RAS actuator assembly and rear suspension member.
3. Remove fixing bolts and nuts of RAS actuator assembly, and then remove RAS actuator assembly from rear suspension member.
INSTALLATION
Note the following, and install in the reverse order of removal.
-
When installing RAS actuator assembly to rear suspension member, check the mounting surfaces of RAS actuator assembly and rear suspension
member for oil, dirt, sand, or other foreign materials.
-
Check rear wheel alignment. See: Alignment/Service and Repair/Rear Suspension.
-
Adjust neutral position of steering angle sensor. See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and
Inspection/Programming and Relearning/Additional Service When Replacing Control Unit/Description See: Brakes and Traction Control/Antilock
Brakes / Traction Control Systems/Testing and Inspection/Programming and Relearning/Additional Service When Replacing Control Unit/Special
Repair Requirement See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Programming and
Relearning/Adjustment Of Steering Angle Sensor Neutral Position/Description See: Brakes and Traction Control/Antilock Brakes / Traction
Control Systems/Testing and Inspection/Programming and Relearning/Adjustment Of Steering Angle Sensor Neutral Position/Special Repair
Requirement, "ADJUSTMENT OF STEERING ANGLE
SENSOR NEUTRAL POSITION : Special Repair Requirement".