FX35 RWD V6-3.5L (VQ35HR) (2010)
![background image](/infiniti/fx35_rwd/v6-3.5l_(vq35hr)/Page-1248006.png)
Removal and Installation
FRONT LOWER LINK
Removal and Installation
REMOVAL
1. Remove tire with power tool.
2. Set suitable jack under axle assembly to relieve the coil spring tension.
3. Remove shock absorber mounting bolts from front lower link. See: Suspension Strut / Shock Absorber/Service and Repair/Removal and
Replacement/Shock Absorber/Exploded View.
4. Remove front lower link mounting bolts and nuts from axle housing with power tool.
5. Remove stabilizer clamp and stabilizer bushing. See: Stabilizer Bar/Service and Repair/Removal and Replacement/Rear Stabilizer/Exploded
View.
6. Remove front lower link mounting bolts and nuts from rear suspension member with power tool, and remove front lower link.
INSTALLATION
Note the following, and install in the reverse order of removal.
-
Perform final tightening of rear suspension member and axle installation position (rubber bushing), under unladen conditions with tires on level
ground.