FX35 RWD V6-3.5L (VQ35HR) (2010)
5. Disconnect heated oxygen sensor 2 connectors (A).
White arrow : Vehicle front
6. Remove heated oxygen sensor 2 harness (B) from clips (1).
7. Remove harness bracket (2) from A/T assembly. See: Service and Repair/Overhaul.
8. Remove front propeller shaft. .
9. Remove front drive shaft (right side). .
10. Remove A/T fluid cooler tubes from A/T assembly and engine assembly.
11. Plug up opening such as the A/T fluid cooler tube hole.
12. Remove clips and bracket.
13. Remove A/T fluid cooler tubes from the vehicle.
CAUTION:
Be careful not to bend A/T fluid cooler tubes.
INSTALLATION
Note the following, and install in the reverse order of removal.
CAUTION:
Never reuse copper washer.
-
Refer to the following when installing A/T fluid cooler hoses.
- The illustrations indicate the view from the hose ends.
White arrow D : Vehicle front
White arrow E : Vehicle upper
- When installing hose clamps center line of each hose clamp tab should be positioned as shown in the figure.
- Insert A/T fluid cooler hoses according to dimension "L" described below.