FX45 AWD V8-4.5L (VK45DE) (2006)
b. Make sure that both intake and exhaust cam noses of No. 1 cylinder (engine front side of left bank) are located as shown in the figure.
^
If not, turn crankshaft one revolution (360 degrees) and align as shown in the figure.
8. Remove crankshaft pulley as follows:
a. Remove rear plate cover, and set ring gear stopper (SST).
b. Loosen crankshaft pulley bolt, and then pull crankshaft pulley with both hands to remove it.
CAUTION:
^
Do not remove crankshaft pulley bolt. Keep loosened crankshaft pulley bolt in place to protect removed crankshaft pulley from dropping.
^
Do not remove balance weight (inner hexagon bolt) at the front of crankshaft pulley.
9. Remove oil pan and oil strainer.
10. Remove front cover as follows:
a. Loosen mounting bolts in reverse order as shown in the figure.
b. Use seal cutter [SST: KV10111100 (J37228)] to cut liquid gasket for removal.
CAUTION:
^
Exercise care not to damage mating surfaces.
^
After removal, handle front cover carefully so it does not tilt, cant, or warp under load.
11. Remove front oil seal from front cover using suitable tool.
^
Use screw driver for removal.
CAUTION: Be careful not to damage front cover.