FX45 AWD V8-4.5L (VK45DE) (2006)
/Page-542002.png)
the balance weight center is aligned with the wheel balancer indication position (angle).
CAUTION:
^
Always use genuine NISSAN adhesion balance weights.
^
Balance weights are unreusable; always replace with new ones.
^
Do not install more than three sheets of balance weight.
c. If calculated balance weight value exceeds 50 grams (1.76 ounces), install two balance weight sheets in line with each other (as shown in the
figure).
CAUTION: Do not install one balance weight sheet on top of another.
3. Start wheel balancer again.
4. Install drive-in balance weight on inner side of road wheel in the wheel balancer indication position (angle).
CAUTION: Do not install more than two balance weights.
5. Start wheel balancer. Make sure that inner and outer residual unbalance values are 5.0 grams (0.2 ounces) each or below.
^
If either residual unbalance value exceeds 5.0 grams (0.2 ounces), repeat installation procedures.
