FX45 AWD V8-4.5L (VK45DE) (2006)
Fuel Line Coupler: Service and Repair
Disconnect quick connector
Disconnect quick connector as follows:
-
Hold the sides of connector, push in tabs and pull out tube.
-
If quick connector sticks to tube of main fuel level sensor unit, push and pull quick connector several times until they start to move.Then
disconnect them by pulling.
CAUTION:
-
Quick connector can be disconnected when the tabs are completely depressed. Do not twist it more than necessary.
-
Do not use any tools to disconnected quick connector.
-
Keep resin tube away from heat. Be especially careful when welding near the resin tube.
-
Prevent acid liquid such as battery electrolyte, etc.from getting on resin tube.
-
Do not bend or twist resin tube during installation and is connection.
-
Do not remove the remaining retainer on hard tube (or the equivalent) except when resin tube or retainer is replaced.
-
When resin tube or hard tube (or the equivalent) is replaced, also replace retainer with new one.
Retainer color: White