FX45 AWD V8-4.5L (VK45DE) (2006)
c. Tighten oil pan mounting bolts to the specified torque in numerical order shown in the figure after temporarily tightening them. Refer to
AT-239, "COMPONENTS".
CAUTION: Do not reuse oil pan mounting bolts.
16. Install drain plug to oil pan, and then tighten drain plug to the specified torque. Refer to AT-239, "COMPONENTS".
CAUTION: Do not reuse drain plug gasket.
17. Pull up A/T assembly harness connector.
CAUTION: Be careful not to damage connector.
18. Install snap ring to A/T assembly harness connector.
19. Connect A/T assembly harness connector.
20. Connect heated oxygen sensor 2 harness connector.
21. Install front cross bar.
22. Pour ATF into A/T assembly.
23. Connect the battery cable to the negative terminal.