FX45 AWD V8-4.5L (VK45DE) (2006)
4. Apply anti-corrosion oil to the thread and seat of new drive pinion lock nut, and temporarily tighten drive pinion lock nut to drive pinion.
CAUTION: Do not reuse drive pinion lock nut.
5. Tighten to drive pinion lock nut, while adjust total preload torque.
Tool number A: ST3127S000 (J-25765-A)
Drive pinion lock nut tightening torque: 127.4 - 245.0 Nm (13.0 - 25.0 kg-m, 94 - 181 ft. lbs.)
Total preload torque: 1.56 - 2.65 Nm (0.16 - 0.27 kg-m, 14 - 23 inch lbs.)
CAUTION:
^
Adjust to the lower limit of the drive pinion lock nut tightening torque first.
^
After adjustment, rotate drive pinion back and forth 2 to 3 times to check for unusual noise, rotation malfunction, and other malfunctions.
^
If measured value is out of the specification, remove final drive assembly and disassemble drive pinion parts to check and adjust each part.
6. Install front propeller shaft.
7. Install side shaft assembly.
8. Install front drive shaft both.
9. Refill gear oil to the final drive and check oil level.
10. Check the final drive for oil leakage.
Side Oil Seal
SIDE OIL SEAL
Removal and Installation
NOTE: Left side oil seal is attached to engine assembly. Replace it when front final drive assembly is removed from vehicle.
REMOVAL
Right Side:
1. Remove the front drive shaft.
2. Remove the side oil seal using a flat-bladed screwdriver.