FX45 AWD V8-4.5L (VK45DE) (2006)
Axle Shaft Assembly: Service and Repair
Front Axle
Left Side
Removal and Installation (Left Side)
REMOVAL
1. Remove tires from vehicle with power tool.
2. Remove undercover with power tool.
3. Remove cotter pin. Then remove lock nut from drive shaft with power tool.
4. Remove wheel sensor harness from strut assembly.
CAUTION: Do not pull on wheel sensor harness.
5. Remove brake hose lock plate. Then remove brake hose from strut assembly.
6. Remove fixing bolts and nuts between strut assembly and steering knuckle with power tool.
7. Using a puller (suitable tool), remove drive shaft from steering knuckle.
CAUTION: When removing drive shaft, do not apply an excessive angle to drive shaft joint. Also be careful not to excessively extend slide joint.
8. Remove fixing bolt of front final drive side assembly drive shaft with power tool, then remove drive shaft from vehicle.
INSPECTION AFTER REMOVAL
^
Move joint up/down, left/right, and in the axial direction. Check for any rough movement or significant looseness.
^
Check boot for cracks or other damage, and also for grease leakage.