FX45 AWD V8-4.5L (VK45DE) (2006)
Front Door Window Regulator: Overhaul
Disassembly and assembly
REGULATOR ASSEMBLY
Disassembly
Remove the power window motor and guide rail from the module assembly.
Assembly
Assemble in the reverse order of disassembly.
Inspection after Installation
SETTING OF LIMIT SWITCH
Setting of Limit Switch
If any of the following work has been done, set the limit switch (integrated in the motor).
-
Removal and installation of the motor from the regulator.
-
Operate the regulators as a unit.
-
Installation of the new glass.
-
Installation of the new glass run.
Resetting
After installing each component to the vehicle, follow the steps below.
1. Raise the glass to the top position.
2. While pressing and holding the reset switch, lower the glass to the bottom position.
3. Release the reset switch, and check the reset switch returns to the original position, and then raise the glass to the top position.
CAUTION: Do not operate the glass automatically to raise the glass to the top position.
FITTING INSPECTION
-
Make sure the glass is securely fit into the glass run groove.
-
Lower the glass slightly [approx. 10 to 20 mm (0.39 to 0.79 in)] and make sure the clearance to the sash is parallel. If the clearance between the
glass and sash is not parallel, loosen the regulator mounting bolts, guide rail mounting bolts, and glass and guide rail mounting bolts to correct the
glass position.