FX50 AWD V8-5.0L (VK50VE) (2009)
Rear Bumper: Service and Repair
Removal and Installation
REAR BUMPER
Removal and Installation
REMOVAL
CAUTION:
Bumper fascia is made of resin. Never apply strong force to it, and be careful to prevent contact with oil.
1. Fully open back door.
2. Remove rear combination lamps (LH/RH). Refer to See: Lighting and Horns/Turn Signals/Service and Repair/Rear Combination Lamp/Removal
and Installation.
3. Remove bolts (A) and clips (B) (LH/RH) located under rear combination lamps (LH/RH).
4. Remove rear fillet moldings (1) fixing screws (A) (LH/RH).
5. Remove rear fillet moldings fixing pawls and clips (LH/RH). Refer to See: Interior Moulding / Trim/Service and Repair/Fillet Molding/Removal
and Installation.
6. Remove bumper fascia assembly fixing screws (A) (LH/RH).
7. Remove bumper fascia assembly underside fixing clips (A).