FX50 AWD V8-5.0L (VK50VE) (2009)
3. Remove back pillar finisher (1) fixing clip with a remover tool (A).
CAUTION:
Never use an item as a remover tool that could damage body panel.
4. Remove back pillar finisher (1) fixing double-faced adhesive tape (A) and clip with a remover tool (B).
CAUTION:
Never use an item as a remover tool that could damage body panel.
5. Remove back pillar finisher.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
-
Replace double-faced adhesive tape with a new one, if the back pillar finisher is reused.
-
Remove double-faced adhesive tape remaining on body panel and back of back pillar finisher with a double-faced adhesive tape remover,
after removing back pillar finisher.
-
When installing, visually check the back pillar finisher and the clips, then replace them with new parts, if they are damaged.
-
Never wash the vehicle within 24 hours after installing so as to keep adhesive.