FX50 AWD V8-5.0L (VK50VE) (2009)
-
Never deform or bend the brake tubes when installing the brake booster.
-
Always use a new gasket between the brake booster and the dash panel.
-
Replace the clevis pin if it is damaged. Refer to See: Brake Pedal Assy/Service and Repair/Procedures.
-
Install the brake pedal assembly and brake booster mounting nuts, and tighten it to the specified torque.
-
After installation, perform the air bleeding. Refer to See: Brake Bleeding/Service and Repair.
CAUTION:
Never reuse drained brake fluid.
Exploded View
VACUUM LINES
Exploded View
VQ35HR
VK50VE