Infiniti Workshop Service and Repair Manuals

NOTE:
-

The figure shows the electric throttle control actuator (bank 1) viewed from the air duct side.

-

Viewed from the air duct side, the order of tightening mounting bolts of electric throttle control actuator (bank 1) is the same as that of the electric
throttle control actuator (bank 2).

-

Perform the "Throttle Valve Closed Position Learning" when harness connector of electric throttle control actuator is disconnected. Refer to See:
Powertrain Management/Computers and Control Systems/Testing and Inspection/Programming and Relearning/Inspection and Adjustment/VIN
Registration/Special Repair Requirement See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Programming and
Relearning/Inspection and Adjustment/Accelerator Pedal Released Position Learning/Description See: Powertrain Management/Computers and
Control Systems/Testing and Inspection/Programming and Relearning/Inspection and Adjustment/Accelerator Pedal Released Position
Learning/Special Repair Requirement See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Programming and
Relearning/Inspection and Adjustment/Throttle Valve Closed Position Learning/Description See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Programming and Relearning/Inspection and Adjustment/Throttle Valve Closed Position Learning/Special Repair
Requirement, "THROTTLE VALVE CLOSED POSITION LEARNING : Description".

-

Perform the "Idle Air Volume Learning" and "Throttle Valve Closed

Position Learning" when electric throttle control actuator is replaced. Refer to See: Powertrain Management/Computers and Control Systems/Testing
and Inspection/Programming and Relearning/Inspection and Adjustment/Idle Air Volume Learning/Description See: Powertrain
Management/Computers and Control Systems/Testing and Inspection/Programming and Relearning/Inspection and Adjustment/Idle Air Volume
Learning/Special Repair Requirement, "IDLE AIR VOLUME
 See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Programming and Relearning/Inspection and
Adjustment/Throttle Valve Closed Position Learning/Description.

Water Hose
Insert hose by 27 to 32 mm (1.06 to 1.26 in) from connector end.

Vacuum Hose
Refer to See: Powertrain Management/Emission Control Systems/Evaporative Emissions System/Testing and Inspection/EVAP Leak Check.