FX50 AWD V8-5.0L (VK50VE) (2009)
/Page-319002.png)
3. With box wrench, and while securely holding the hexagonal part in pulley center of auto tensioner (1), move wrench handle in the direction of
arrow (loosening direction of tensioner).
CAUTION:
-
Never place hand in a location where pinching may occur if the holding tool accidentally comes off.
-
Never loosen the hexagonal part in center of auto tensioner pulley (Never turn it clockwise). If turned clockwise, the complete auto
tensioner must be replaced as a unit, including the pulley.
4. Under the above condition, insert a metallic bar (A) of approximately 6 mm (0.24 in) in diameter (hexagonal bar wrench shown as example in the
figure) through the holding boss to lock auto tensioner pulley arm.
-
Leave auto tensioner pulley arm locked until belt is installed again.
5. Remove alternator, water pump and A/C compressor belt.
Power Steering Oil Pump Belt
1. Remove engine undercover with power tool.
2. Remove alternator, water pump and A/C compressor belt. Refer to "Alternator, Water Pump and A/C
Compressor Belt".
3. With box wrench, and while securely holding the hexagonal part in pulley center of auto tensioner (1), move wrench handle in the direction of
arrow (loosening direction of tensioner).
CAUTION:
-
Never place hand in a location where pinching may occur if the holding tool accidentally comes off.
-
Never loosen the hexagonal part in center of auto tensioner pulley (Never turn it clockwise). If turned clockwise, the complete auto
tensioner must be replaced as a unit, including the pulley.
4. Under the above condition, insert a metallic bar (A) of approximately 6 mm (0.24 in) in diameter (hexagonal bar wrench shown as example in the
figure) through the holding boss to lock auto tensioner pulley arm.
-
Leave auto tensioner pulley arm locked until belt is installed again.
5. Remove power steering oil pump belt.
INSTALLATION
Note the following item, and install in the reverse order of removal.
CAUTION:
-
Check drive belts are securely installed around all pulleys.
-
Check drive belts are correctly engaged with the pulley groove.
-
Check for engine oil and engine coolant are not adhered drive belts and pulley groove.
