FX50 AWD V8-5.0L (VK50VE) (2009)
-
Configuration is different for each vehicle model. Confirm configuration of each vehicle model.
-
Never perform "WRITE CONFIGURATION" except for new CAN gateway.
Special Repair Requirement
INSPECTION AND ADJUSTMENT
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (CAN GATEWAY) : Special Repair Requirement
1.SAVING VEHICLE SPECIFICATION
CONSULT-III Configuration
Perform "READ CONFIGURATION" to save or print current vehicle specification.
NOTE:
If "READ CONFIGURATION" can not be used, use the "WRITE CONFIGURATION - Manual selection" after replacing CAN gateway.
- GO TO 2.
2.REPLACE CAN GATEWAY
Replace CAN gateway. Refer to See: Service and Repair/Exploded View.
- GO TO 3.
3.WRITING VEHICLE SPECIFICATION
CONSULT-III Configuration
Perform "WRITE CONFIGURATION - Config file" or "WRITE CONFIGURATION - Manual selection" to write vehicle specification. Refer to See:
Inspection and Adjustment/Configuration (CAN Gateway)/Special Repair Requirement.
- WORK END
Description
INSPECTION AND ADJUSTMENT
CONFIGURATION (CAN GATEWAY) CONFIGURATION (CAN GATEWAY) : Description
Vehicle specification needs to be written with CONSULT-III because it is not written after replacing CAN gateway.
Configuration has three functions as follows
CAUTION:
-
When replacing CAN gateway, you must perform "WRITE CONFIGURATION" with CONSULT-III.
-
Complete the procedure of "WRITE CONFIGURATION" in order.
-
If you set incorrect "WRITE CONFIGURATION", incidents might occur.
-
Configuration is different for each vehicle model. Confirm configuration of each vehicle model.
-
Never perform "WRITE CONFIGURATION" except for new CAN gateway.
Special Repair Requirement
INSPECTION AND ADJUSTMENT
CONFIGURATION (CAN GATEWAY) : Special Repair Requirement
1.WRITING MODE SELECTION
CONSULT-III Configuration
Select "CONFIGURATION" of CAN gateway.
When writing saved data-GO TO 2.
When writing manually-GO TO 3.
2.PERFORM "WRITE CONFIGURATION - CONFIG FILE"
CONSULT-III Configuration
Perform "WRITE CONFIGURATION - Config file".
- WORK END
3.PERFORM "WRITE CONFIGURATION - MANUAL SELECTION"
CONSULT-III Configuration
1. Select "WRITE CONFIGURATION - Manual selection".
2. Identify the correct model and configuration list. Refer to See: Inspection and Adjustment/Configuration (CAN Gateway)/Configuration List.