FX50 AWD V8-5.0L (VK50VE) (2009)
-
Be careful to keep clip from interfering with O-ring. If interference occurs, replace O-ring.
b. Insert fuel injector into fuel tube with clip attached.
-
Insert it while matching it to the axial center.
-
Insert fuel injector so that protrusion (G) of fuel tube matches cutout (F) of clip.
-
Check that fuel tube flange (A) is securely fixed in flange fixing groove (D) on clip.
CAUTION:
Insert fuel injector at 147 N (15 kg, 33.1 lb) or less to prevent damage to the parts c. Check that installation is complete by checking that fuel
injector does not rotate or come off.
-
Check that protrusions of fuel injectors and fuel tube are aligned with cutouts of clips after installation.
5. Install fuel tube and fuel injector assembly.
-
Tighten mounting bolts (a) first. Then tighten mounting bolts
(b) shown in the figure.
Tightening Torque 1st step : 10.1 Nm (1.0 kg-m, 7 ft-lb)
Tightening Torque 2nd step : 23.6 Nm (2.4 kg-m, 17 ft-lb)
CAUTION:
-
Be careful not to let tip of injector nozzle come in contact with other parts.
-
Insert fuel injector at 147 N (15 kg, 33.1 lb) or less to prevent damage to the parts
6. Install quick connecters as per the following:
-
Unless otherwise indicated, the installation to the engine side and centralized under-floor piping side is exactly alike.