G20 L4-2.0L (SR20DE) (1992)
Inhibitor Switch: Adjustments
Inhibitor Switch
1.
Remove control cable end from manual shaft, then set manual shaft in ``N'' range.
2.
Loosen inhibitor switch attaching bolts, then insert a 4.0 mm (0.157 in) diameter pin into adjustment holes on both inhibitor switch and manual
shaft as near vertical as possible.
3.
Tighten inhibitor switch attaching bolts, then remove pin from adjusting hole.
4.
Install and adjust control cable, then check continuity of inhibitor switch.