G20 L4-2.0L (SR20DE) (1992)
![background image](/infiniti/g20/l4-2.0l_(sr20de)/Page-939003.png)
-
Check clutch disc for backlash of spline and runout of facing.
Maximum backlash of spline (at outer edge of disc): 0.9 mm (0.035 in).
Runout limit: 1.0 mm (0.039 in).
Distance of runout check point (from hub center): 2.5 mm (4.04 in).
-
Check clutch disc for burns, discoloration or oil or grease leakage. Replace if necessary.
INSTALLATION
-
Apply recommended grease to contact surface of splines.
Note: Too much lubricant may damage clutch disc facing.
Clutch Cover and Flywheel
INSPECTION AND ADJUSTMENT
-
Check clutch cover, installed on vehicle, for uneven diaphragm spring toe height.
-
Uneven limit: 0.7 mm (0.028 in). If out of limit, adjust the height with tool.
FLYWHEEL INSPECTION
CAUTION: Do not allow any magnetic materials to contact the ring gear teeth.
-
Inspect contact surface of flywheel for slight burns or discoloration. Clean flywheel with emery paper.
-
Check flywheel runout.
INSTALLATION