G35 Coupe V6-3.5L (VQ35DE) (2003)
16.
Connect the other end of the new Sub-Harness to the existing Brake Light Switch Harness Connector (see Figure 8).
17.
Route and secure the Sub-Harness as follows:
a.
Route the Sub-Harness as shown in Figure 9.
b.
Use the Tie Band (supplied in the kit) to secure the Sub-Harness to the Instrument Panel Metal Bracket (see Figure 9).
IMPORTANT:
Make sure the Sub-Harness is correctly routed and is NOT rubbed, chaffed, or pinched by surrounding components.
NOTE:
Do not re-install the Instrument Lower Panel or VDC Unit (if equipped) at this time. You still need to confirm/adjust the clearance on the new Brake
Light Switch (covered in the next step).
Confirm/Adjust Brake Light Switch Clearance
18.
Re-connect the negative battery cable.