G35 Sedan V6-3.5L (VQ35HR) (2008)
^
Be careful not to pinch harnesses.
^
Completely remove all moisture, oil and old gasket, etc. from oil pan mounting surface.
10. Tighten oil pan mounting bolts to the specified torque in numerical order shown in the figure after temporarily tightening them. Tighten necessary
oil pan mounting bolts with specified torque.
<---: Vehicle front
CAUTION: Do not reuse oil pan mounting bolts.
11. Install drain plug to oil pan. Tighten a necessary drain plug with specified torque.
CAUTION: Do not reuse drain plug gasket.
12. Install bracket (2) to transmission assembly.
<---: Vehicle front
<---: Bolt
13. Install heated oxygen sensor 2 harness (B) to clips (1).
14. Connect heated oxygen sensor 2 harness connector (A).
15. Install exhaust mounting bracket.
16. Install control rod.
17. Install rear propeller shaft.
18. Install heat insulator.
19. Install exhaust front tube and center muffler.
20. Pour ATF into A/T assembly.
21. Connect the battery cable to the negative terminal.
2WD: Inspection
INSPECTION AFTER REMOVAL