G35 Sedan 2WD V6-3.5L (VQ35DE) (2005)
/Page-1129002.png)
AWD MODEL
REMOVAL
Disconnect each joint and mounting using power tool.
INSTALLATION
Note to the following, and install in the reverse order of removal.
CAUTION:
^
Always replace exhaust gaskets with new ones when reassembling.
^
If insulator is badly deformed, repair or replace it. If deposits such as mud pile up on the insulator, remove them.
^
When installing insulator avoid large gaps or interference between insulator and each exhaust pipe.
^
Remove deposits from the sealing surface of each connection. Connect them securely to avoid gas leakage.
^
Temporarily tighten mounting nuts. Check each part for unusual interference, and then tighten them to the specified torque.
^
When installing each mounting rubber, avoid twisting or unusual extension in up/down and rights left directions.
Inspection After Installation
^
With the engine running, check exhaust tube joints for gas leakage and unusual noises.
^
Check to ensure that mounting brackets and mounting rubbers are installed properly and free from undue stress. Improper installation could result
in excessive noise and vibration.
^
Make sure that clearance between finisher and rear bumper is even.
