G35 Sedan 2WD V6-3.5L (VQ35DE) (2005)
Tie Rod: Service and Repair
INSPECTION AFTER DISASSEMBLY
Boot
Check boot for cracks and deformation. Replace it, if necessary.
Rack
Check rack for damage and wear. Replace it, if necessary.
Sub-Gear Assembly
^
Check pinion gear for damage and wear. Replace it, if necessary.
^
Check bearing while rotating it. Replace bearing if bearing ball race was dented, worn, or damaged.
Gear Housing Assembly
Check gear housing assembly for damage and scratches (inner wall). Replace it, if necessary.
Outer Socket and Inner Socket
Swing Torque
^
Hook a spring balance at the point shown in the figure. Confirm if the reading is within the specification. When ball stud and inner socket start
moving the measured value must be within the specification. If the reading is outside the specification, replace socket.
Specified value
Rotating torque
^
Using a preload gauge (SST), check if reading is within the value specified. If the value is outside the standard, replace outer sockets.
Rotating torque 0.30 - 2.90 Nm (0.03 - 0.29 kgf-m, 3 - 25 inch lbs.)
Axial End Play