G35 Sedan 2WD V6-3.5L (VQ35DE) (2005)
/Page-1395003.png)
^
Align matching marks to install propeller shaft to final drive companion flange, and then tighten to specified torque. Refer to Components.
^
Install center bearing mounting bracket (Upper) with its arrow mark facing forward.
^
Adjust position of mounting bracket sliding back and forth to prevent play in thrust direction of center bearing insulator. Install bracket to vehicle.
^
After assembly, perform a driving test to check propeller shaft vibration. If vibration occurred, separate propeller shaft from final drive. Reinstall
companion flange after rotating it by 90, 180, 270 degrees. Then perform driving test and check propeller shaft vibration again at each point.
^
If propeller shaft or final drive has been replaced, connect them as follows:
1. Install propeller shaft while aligning its matching mark A with the matching mark B on the joint as close as possible.
2. Temporarily tighten bolts and nuts.
3. Press down propeller shaft with matching mark C facing upward. Then tighten fixing bolts and nuts to the specified torque. Refer to Components.
