G35 Sedan 2WD V6-3.5L (VQ35DE) (2005)
8. Install boot securely into grooves (indicated by * marks) shown in the figure.
CAUTION: If there is grease on boot mounting surfaces (indicated by* marks) of shaft and housing, boot may come off. Remove all grease from
surfaces.
9. Make sure boot installation length L is the length indicated. Insert a flat-bladed screwdriver or similar tool into smaller side of boot. Bleed air from
boot to prevent boot deformation.
Standard value
Boot installation Length L: 93.9 mm (3.697 inch)
CAUTION:
^
Boot may break if boot installation length is less than standard value.
^
Take care not to touch the tip of screw driver to inside of boot.
10. Secure big and small ends of boot with new boot bands as shown in the figure.
NOTE: Discard old boot bands; replace with new ones.
11. After installing housing and shaft, rotate boot to check whether 1: or not the actual position is correct. If boot position is not correct, secure boot
with new boot band again.
Wheel Side
1. Insert the amount grease (NISSAN genuine grease or equivalent) into joint subassembly serration hole until grease begins to ooze from ball groove
and serration hole. After insert grease, use a shop cloth to wipe off old grease that has oozed out.