G37 Convertible V6-3.7L (VQ37VHR) (2010)
a. Tighten large side of boot with boot clamp (stainless wire).
Wire length "L" : 370 mm (14.57 in)
b. Wrap clamp around boot groove for two turns. Insert a flat-bladed screwdriver in loops on both ends of wire. Twist 4 to 4.5 turns while pulling
them with force of approximately 98 N (10 kg, 22 lb).
c. Twist boot clamp as shown. Pay attention to relationship between winding and twisting directions.
d. Twisted area (A) of clamp is in the opposite side of adjusting screw (1) as shown in the figure (to prevent contact with other parts).
e. Bent cut end of the wire as shown in the figure after twisting the wire 4 to 4.5 turns so that cut end does not contact with boot.
CAUTION:
Keep gap from cylinder tube 5 mm (0.20 in) or more.
Wire angle "A" : 45°
13. Install cylinder tubes to gear housing assembly.
14. Install low pressure piping.